We didn’t expect that the local government was so efficient; all the things went with a minimum（ ）and maximum speed.
It can’t hurt to look at the “good job” lists to see if any of the careers on it appeal to you, but you shouldn’t use the list to（ ）your choice.
Big waves turned（ ）the boat, causing many people to fall into water.
The need for solar electricity is clear. It is safe, ecologically sound, efficient, continuously available, and it has no moving parts. The basic problem with the use of solar photovoltaic devices is economics, but until recently very little progress had made toward the development of low-cost photovoltaic devices. The larger part of research funds has been devoted to the study of single-crystal silicon solar cells, despite the evidence that this technique holds little promise. The reason for this pattern is understandable and historical. Crystalline silicon, however, is particularly unsuitable to terrestrial solar cells.Crystalline silicon solar cells work well and successfully used in the space program, where cost is not an issue. While single crystal silicon lm been proven in extraterrestrial use with efficiencies as high as 18 percent, and other more expensive and scarce materials can have ever higher efficiencies, costs must be reduced by a factor of more that 100 to make them practical for commercial uses. Beside the fact that the starting crystalline silicon is expensive, 95 percent of it is wasted and does not appear m the final device Recently, there have been some imaginative attempts to make polycrystalline and ribbon silicon which are lower in cost than high-quality single crystals; but to date the efficiencies of these apparently lower-cost materials have been unacceptably small Moreover, these materials are cheaper only because of the introduction of disordering in crystalline semiconductors, and disorder degrades the efficiency of crystalline solar cells.This difficulty can be avoided by preparing completely disordered or amorphous materials. Amorphous materials have disordered atomic structure as compared to crystalline materials: that is, they only short-range order rather that the ling-range periodicity of crystals. The advantages of amorphous solar cells are impressive. Whereas crystalline silicon must be made 200 microns thick to absorb a sufficient amount of sunlight for efficient energy conversion only I microns of the proper amorphous materials is necessary. Crystalline silicon solar cells cost in excess of 100 per square foot, but amorphous films can be created at a cost of about 50 cents per square foot.Although many scientists wore aware of the very low cost of amorphous solar cells, they felt that they could never be manufactured with the efficiencies necessary to contribute significantly to the demand for electric power. This was based on misconception about the feature which determines efficiency. For example, it is not the conductivity of the material in the dark which is relevant, but only the photoconductivity, that is, the conductivity in the presence of sunlight. Already, solar cells with efficiencies well above 6 percent have been developed using amorphous materials, and further research will doubtless find even less costly amorphous materials with higher efficiencies.1.The author is primarily concerned with（ ）.2.The author mentions recent attempts to make polycrystalline and ribbon silicon primarily in order to （ ）.3.The material in the passage could best be used in an argument for （ ）.4.The tone of the passage can best be described as（ ）.
The remarkable （ ）of life on the Galapagos Islands inspired Charles Darwin toestablish his theory of evolution.
The residents, （ ）had been damaged by the flood, were given help by the Red Cross.